How to Reset a Canon MP198 Printer Error Code 27 (Waste ink pad full)

How to fix the printer canon MP198 and MP250 to canon which displays an error code 27 di lamps indicator, this error arises because the ink discharge reservoir is full (not the actual full betul2, the-the only indicator in the chip mobo printer is full because too many prints). The way is easy, if lazy to open the printer (ink discharge cleaning) is sufficient to use the program to reset the printer to be used normally again.

Steps to reset Canon printer:

1. Turn off the printer (Disconnect the electrical plugs) then cook in the back.
2. Press and hold the STOP / RESET then press and hold the POWER button
3. Remove the STOP / RESET (POWER button is not released)
4. Press STOP / RESET 2 (two) times, then release the button POWER
5. Let the Green Light berkelium until the printer head stopped moving and LED panel shows the number zero
6. The computer will detect the new hardware, just ignore ....
7. This situation shows the MP198 printer in a state SERVICE MODE and is ready to be reset
8. Download (Download) Utility to reset the Canon MP198 printer and class.
9. Extract and run the program (ServiceTool_V1074.exe)
10. Previously prepared first two sheets of paper (the former also GPP)

11. Click the "MAIN", wait a minute (printer is busy), then the printer will print one page with the words "D = 000.0 Ps = 000.0"
12. Then click the "Clear EEPROM"
13. Then click "EEPROM", and the printer will print the results Resetter. One of his lines like this:
"TPage (TTL = 00000 COPY = 00000)"
14. Turn off the printer by pressing the POWER
15. Done ....

Thus the repeated notes on how to reset printer canon, especially canon mp198, and MP250 
Please Download Program reset ya Here